AGFA CR 30-X User Manual page 52

52 | CR 30-X, CR 30-Xm | Getting started
3. Switch on the ID Tablet.
Only in a configuration with ID Tablet.
For more information, refer to the document Getting Started with the ID
Tablet.
4. Make sure the digitizer is connected to the control PC and that the control
PC is running the appropriate NX software.
For more information, refer to the NX User Manual.
5. Start NX.
For detailed information about starting up NX, refer to the NX User
Manual, document 4420.
2386I EN 20151020 1518