Initialization To Default Settings - Danfoss VLT AQUA Drive FC 200 Instruction Manual

VLT AQUA High Power Instruction Manual

4.1.11. Initialization to Default Settings

Initialize the adjustable frequency drive using default settings in two ways:
Recommended initialization (via par. 14-22)
1.
2.
3.
4.
5.
Par. 14-22 initializes everything except:
14-50
8-30
8-31
8-32
8-35
8-36
8-37
15-00 to 15-05
15-20 to 15-22
15-30 to 15-32
Manual initialization
1.
2a. Press [Status] - [Main Menu] - [OK]
2b. Press [Menu] while the LCP 101, Nu-
3.
4.
Select par. 14-22
Press [OK]
Select "Initialization"
Press [OK]
Cut off the line power supply and
wait until the display turns off.
NOTE
Keeps parameters selected in
RFI 1
Protocol
Address
Baud Rate
Minimum Response Delay
Max Response Delay
Max Inter-char Delay
Operating data
Historical log
Fault log
Disconnect from the power supply
and wait until the display turns off.
at the same time the LCP 102,
Graphical Display is powering up.
merical Display is powering up.
Release the keys after 5 s.
The adjustable frequency drive is
now programmed according to de-
fault settings.
NOTE
When you carry out manual initialization, you also reset serial communication, RFI
filter settings (par. 14-50) and fault log settings.
Removes parameters selected in
®
MG.20.P1.22 - VLT is a registered Danfoss trademark.
4. How to program the adjustable frequency
6. Reconnect the line power supply -
the adjustable frequency drive is
now reset.
7. Change par. 14-22 back to
Operation .
Personal Menu
with default factory setting.
This procedure initializes all except:
Operating Hours
15-00
15-03 Power-ups
Overtemps
15-04
15-05 Overvolts
Personal Menu
.
drive
4
Normal
99