Danfoss VLT AQUA Drive FC 200 Instruction Manual page 96

4. How to program the adjustable frequency
drive
4.1.4. Main Menu Mode
Both the GLCP and NLCP provide access to the
Main Menu mode. Select Main Menu mode by
pressing the [Main Menu] key. Illustration 6.2
shows the resulting readout, which appears
4
on the display of the GLCP.
Lines 2 through 5 on the display show a list of
parameter groups which can be chosen by
toggling the up and down buttons.
Each parameter has a name and number that remain the same regardless of the programming
mode. In main menu mode, the parameters are divided into groups. The first digit of the param-
eter number (from the left) indicates the parameter group number.
All parameters can be changed in the main menu. The configuration of the unit (par. 1-00) will
determine other parameters available for programming. For example, selecting Closed-loop ena-
bles additional parameters related to closed-loop operation. Option cards added to the unit enable
additional parameters associated with the option device.
4.1.5. Parameter Selection
In main menu mode, the parameters are divi-
ded into groups. Select a parameter group
using the navigation keys.
The following parameter groups are accessi-
ble:
96
However, if a value that is too small is used, the adjustable fre-
quency drive's output frequency may become unstable.
4.9: Display example.
Group no.
0
1
2
3
4
5
6
8
9
10
11
13
14
15
16
18
20
21
22
23
24
25
26
4.3: Parameter groups.
®
MG.20.P1.22 - VLT is a registered Danfoss trademark.
VLT AQUA High Power Instruction Manual
Parameter group:
Operation/Display
Load/Motor
Brakes
References/Ramps
Limits/Warnings
Digital In/Out
Analog In/Out
Comm. and Options
Profibus
CAN ser. com. bus
LonWorks
Smart Logic
Special Functions
Drive Information
Data Readouts
Data Readouts 2
Drive Closed-loop
Ext. Closed-loop
Application Functions
Time-based Functions
Fire Mode
Cascade Controller
Analog I/O Option MCB 109