Danfoss VLT AQUA Drive FC 200 Instruction Manual page 84

4. How to program the adjustable frequency
drive
0-39 Display Text 3
Option:
4
0-70 Set Date and Time
Range:
2000-01
-01
00:00 –
2099-12
-01
23:59
0-71 Date Format
Option:
[0]
[1]
[2]
0-72 Time Format
Option:
[0]
[1]
0-74 DST/Summertime
Option:
[0]
[2]
84
[2000-01-01 00:00]
*
* YYYY-MM-DD
DD-MM-YYYY
MM/DD/YYYY
* 24 H
12 H
* OFF
Manual
MG.20.P1.22 - VLT
VLT AQUA High Power Instruction Manual
Function:
In this parameter, it is possible to write an individual text string
for display in the LCP or to be read via serial communication. If
to be displayed permanently, select Display Text 3 in par. 0-20,
0-21, 0-22, 0-23 or 0-24, Display Line XXX
tons on the LCP to change a character. Use the ◀ and ▶ buttons
to move the cursor. When a character is highlighted by the cur-
sor, this character can be changed. A character can be inserted
by placing the cursor between two characters and pressing ▲ or
▼.
Function:
Sets the date and time of the internal clock. The format to be
used is set in par. 0-71 and 0-72.
NOTE
This parameter does not display the actual time.
This can be read in par. 0-89. The clock will not
begin counting until a setting different from de-
fault has been made.
Function:
Sets the date format to be used in the LCP.
Sets the date format to be used in the LCP.
Sets the date format to be used in the LCP.
Function:
Sets the time format to be used in the LCP.
Function:
Choose how Daylight Saving Time/Summertime should be han-
dled. For manual DST/Summertime, enter the start date and
end date in par. 0-76 and 0-77.
®
is a registered Danfoss trademark.
. Use the ▲ or ▼ but-