Danfoss VLT AQUA Drive FC 200 Instruction Manual page 72

4. How to program the adjustable frequency
drive
4.1.2. Quick Menu Mode
The GLCP provides access to all parameters listed under the quick menus. The NLCP only provides
access to the quick set-up parameters. To set parameters using the [Quick Menu] button:
Pressing [Quick Menu] the list indicates the different areas contained in the quick menu.
Efficient Parameter Set-up for Water Ap-
plications
The parameters can easily be set up for the vast majority of the water and wastewater applications
4
only by using the [Quick Menu].
The best way to set parameters using the [Quick Menu] is by following the steps be-
low:
1.
2.
3.
It is recommended to do the set-up in the order listed.
Select
grammed as personal parameters. For example, a pump or equipment OEM may have pre-
programmed these to be in My Personal Menu during factory commissioning to make on-site
commissioning / fine tuning simpler. These parameters are selected in parameter 0-25
Menu
4.1: Quick menu view.
*The display showing depends on choices made in parameter 0-02 and 0-03. The default setting
of parameters 0-02 and 0-03 depends on which region of the world the adjustable frequency drive
is supplied to but can be re-programmed as required.
If No Operation
enable start.
Coast Inverse
If
essary to enable start.
72
Press [Quick Set-up] for selecting basic motor settings, ramp times, etc.
Press [Function Set-ups] for setting up the required functionality of the adjustable fre-
quency drive - if not already covered by the settings in [Quick Set-up].
General Settings, Open-loop Settings
Choose between
My Personal Menu
to display only the parameters, which have been pre-selected and pro-
. Up to 20 different parameters can be defined in this menu.
is selected in terminal 27, no connection to +24 V on terminal 27 is necessary to
(factory default value) is selected in Terminal 27, a connection to +24 V is nec-
MG.20.P1.22 - VLT
VLT AQUA High Power Instruction Manual
Closed-loop Settings
and
Par. Designation
0-01 Language
1-20 Motor Power
1-22 Motor Voltage
1-23 Motor Frequency
1-24 Motor Current
1-25 Motor Nominal Speed
3-41 Ramp 1 Ramp-up Time
3-42 Ramp 1 Ramp-down Time [s]
4-11 Motor Speed Low Limit
4-13 Motor Speed Low High
1-29 Automatic Motor Adapta-
tion
4.2: Quick Set-up parameters
®
is a registered Danfoss trademark.
.
My Personal
[Units]
[kW]
[V]
[Hz]
[A]
[RPM]
[s]
[RPM]
[RPM]
[AMA]