Danfoss VLT AQUA Drive FC 200 Instruction Manual page 44

3. How to Install
The pedestal has been partially assembled.
Before installing the drive on to the pedestal,
it is important to anchor the pedestal to the
floor using the four pedestal mounting holes.
The holes can accommodate up to M12 bolts
(not included in the kit).
CAUTION: The drives are top heavy and may
3
fall over if the pedestal is not anchored to the
floor.
The entire assembly may also be supported by
using the drive top mounting holes to anchor
it to a wall structure.
The completely assembled pedestal with ven-
ted front cover and two side covers installed.
Multiple adjustable frequency drives may be
mounted side by side. The interior side closing
plates are left off.
NOTE: The front and side cover mounting
screws are now recessed M6 Torx socket flat
head screws.
Install the adjustable frequency drive by low-
ering it onto the pedestal. The adjustable fre-
quency drive must hang over the front of the
pedestal to clear the retaining bracket on the
rear of the pedestal. After the adjustable fre-
quency drive has been placed on the pedestal,
slide the adjustable frequency drive so that it
engages with the retaining bracket on the
pedestal and mount screws as shown.
44
3.62: Pedestal partially assembled
3.63: Final assembled pedestal.
3.64: Mount the drive onto pedestal.
®
MG.20.P1.22 - VLT is a registered Danfoss trademark.
VLT AQUA High Power Instruction Manual