Setting the Ergo handle
The Ergo handle
ergonomic gripping position.
• To do this, loosen the fastening screw
• Turn the handle
4.5
Assembling the knife holder SN
Installing the intermediate plate
Warning
Important!
The mounting table must be absolutely clean and dry. There must not be any foreign particles on it.
Otherwise, sections could become contaminated.
• Lock the knife sledge
moved.
• The intermediate plate
table
(→ Fig. 9-4)
• As shown in
(→ Fig.
index markings
Leica SM2010 R
(→ Fig.
8-1), which is used to move the knife sledge, can be set individually to an
(→ Fig. 8-1)
to the desired position and retighten the screw
1
3
Fig. 8
(→ Fig. 9-1)
in place using the locking knob
(→ Fig. 9-3)
intended for the knife holder SN, is mounted on the mounting
of the knife sledge
(→ Fig.
9), place the intermediate plate on the mounting table. Make sure that the two
(→ Fig. 9-5)
are at the top and point towards the back.
(→ Fig. 8-2)
using a size 6 Allen key
9-1).
Instrument Setup
(→ Fig.
8-3).
(→ Fig.
8-2).
2
(→ Fig. 9-2)
so that it cannot be
4
19