Overview-Propak6 Hardware; Propak6-Back Connectors; Propak6 - Back Connector Definitions - Novatel ProPak6 User Manual

Chapter 1
 Ethernet, Wi-Fi, Bluetooth, high speed USB 2.0 and 4 GB onboard memory available
on all models. Refer to Appendix A, Technical Specifications on page 110, Section
NovAtel Part Numbers for model details.
1.4 Overview
—
The ProPak6 has a series of ports on the back of the unit for connecting specific cables. In the front, the
ProPak6 is outfitted with a number of LEDs to indicate receiver status, buttons to initiate functionality and
access to onboard storage (model dependent).
OSC indicates External Oscillator model
Connector Type
GNSS Antenna
External Oscillator
Power
Expansion
USB
Ethernet
I/O
Serial
Communication Port
16
ProPak6 Hardware
Figure 2: ProPak6—Back Connectors
Table 2: ProPak6 - Back Connector Definitions
Connector Label
ANT 1
ANT 2
or
ANT1
OSC
PWR
EXP.
DEVICE
I/O
COM1
COM2
COM3/IMU
ANT2 indicates Dual Antenna model
GNSS GPS1 and GPS2 antennas (TNC) (model dependent)
or
GNSS GPS1 antenna (TNC) and external oscillator (BNC) (model
dependent)
Refer to Figure 5, Antenna and External Oscillator Ports on
page 24 for details
4-pin LEMO power connector
Refer to Figure 6, Power Port on page 24 for details
9-pin LEMO expansion port for CAN1, CAN2 and an additional USB
host port
Refer to Figure 8, Expansion and I/O Ports on page 25 for details
USB Device (Type micro B) connector
Refer to Figure 7, Ethernet, COM or USB Device Ports on page 24
for details
Ethernet RJ45 connector
Refer to Figure 7, Ethernet, COM or USB Device Ports on page 24
for details
Event Input/output (DB9 female connector)
I/O port is configurable
Refer to Figure 8, Expansion and I/O Ports on page 25 for details
COM1, COM2, COM3/IMU DB9 male communications port
RS-232 and RS-422 selectable via software
Refer to Figure 7, Ethernet, COM or USB Device Ports on page 24
for details
ProPak6 Installation and Operation User Manual Rev 4
Introduction
Description