Setting Snmp Trap Destinations - 3Com 4007 Release Note

94 C 7: D
HAPTER OCUMENTATION
Setting SNMP Trap
Destinations
C
HANGES
The following EME command is not documented in Switch 4007
Implementation Guide:
set snmp trap destination
Network Management Protocol (SNMP) trap to a specific destination.
The correct syntax for this command is:
> set snmp trap destination <community> <number>
Where
<community>
you want to send the trap and
receiver.
— Use this command to set a Simple
is the community string of the selected trap where
is the IP address of the trap
<number>