Setting The Number Of Loops For Chases; Automatic Rewind Mode - Compulite Dlite User Manual

Bounce - The pattern runs the step forwards and backwards. Example: A 5 step chase runs
steps 1,2, 3, 4, 5, and then steps 4, 3, 2, 1.
The default pattern is Normal. The default pattern can be changed in
Defaults
To assign a chase pattern
1 Press
2 Press
The
3
Select the chase.
4 Tap
5 Tap the required pattern.
6 Press

Setting the number of loops for chases

The number of loops determines how many times the chase repeats. When the loop setting is 0
(zero) the chase repeats an infinite number of times. Chases are to loop infinitely require operator
action to stop the chase.
Use the keypad or the wheels to set the number of loops:
Wheel 1 - x1 (units of 1)
Wheel 2 - x10 (units of 10)
To set the number of loops
Example: Set chase 4 to repeat 26 times.
1 Press
2 Select the chase.
3 Tap
The wheels or the keypad can be used to set the number of loops.
4
Turn wheel 2 until arriving at 20.
5 Turn wheel 1 until arriving at 6.
6 Press

Automatic rewind mode

When rewind is enabled, a chase is automatically reset to begin at step 1 each time it receives a go
command. When rewind is not enabled, the chase continues running from the step where it stopped.
To set chase for rewind
1 Press
2 Press
.
Chase Pattern
.
EDIT
.
CHASE
screen is displayed.
Edit Chase
.
PATTERN
or .
STORE UPDATE
.
CHASE
.
# OF LOOPS
or .
STORE UPDATE
.
EDIT
.
CHASE
Programming Lighting Objects
SETUP System Options
DLITE
81