Using The Faders To Set Parameter Levels - Compulite Dlite User Manual

Compulite
Chapter 3
The display format for step parameters depends on the step's definition in the device builder
application. Some examples of step displays are: 2.FL (step at its maximum value) or text,
such as,
,
FULL ON
To set parameter levels
Example: Set levels for color and beam parameters.
1 Select the spots.
2
Set the dimmer intensity.
3
Press
4 Set levels using the wheels.
Or
Select a parameter press
5 Press
6
Set levels using the wheels.
Or
Select a parameter press
To set levels for step parameters
Example: Jump from color to color on the color wheel (CW).
1 Select the spots.
2 Set the dimmer intensity.
3 Press
4
Press the (CW) wheel.
5 Tap
The color wheel jumps from color to color.

Using the faders to set parameter levels

You can also use the faders in context mode to set parameter levels. Example: You have selected 4
spots of the same device type. This device uses 5 DMX channels. When
enabled, faders 1 through 5 control parameters for spot, faders 6 through 7 control parameters for
spot 2, etc.
46
. see "Device Builder" page
Fast Strobe
, and can also be used to set parameter levels.
ZR
to switch wheels to the color bank.
C
@
Note: If the parameter you are looking for is not visible, press
to the next 3 parameters in the bank.
to switch wheels to the beam bank.
B
@
to switch wheels to the color bank.
C
Note: If the parameter you are looking for is not visible, press
to the next 3 parameters in the bank.
STEP UP OR STEP DN
167.
and choose a level using the keypad.
and choose a level using the keypad.
.
again to page
C
again to page
C
is
PARAM CONTROL