Connecting To A Pc; Clearing All Data On Start Up - Compulite Dlite User Manual

The keys' and sliders' mapped ID appears in the crossfader LED display or in the Page/
Mode LED display. All key LEDs are turned on and blink. Fader or slider amplitude is also
displayed.
To exit diagnostics
Press

Connecting to a PC

You can connect Dlite to a PC and use its hard-drive to backup Dlite data or manage show and
device files. The connection is enabled with Microsoft ActiveSync and a Null Modem Cable.
IMPORTANT!
To connect to a PC
1 Connect the Null Modem Cable to the serial connection on Dlite's back panel.
2
Turn on Dlite.
3 Open ActiveSync and setup the PC port [COM 1 or COM2].
4 On Dlite, press
The setup main screen is displayed.
5
Tap
6
Tap
7 Tap
If the connection is successful,
Check for the file "Mobile Devices" in
device data that belongs to Dlite.
ATTENTION!
disabled.

Clearing all data on start up

You may want to occasionally clear Dlite of all data. This is called cold starting the console.
To cold start Dlite
1 Press
2
Continue holding
3
Tap
again.
SETUP
Connect the modem cable before turning on Dlite.
.
SETUP
.
SYSTEM OPTIONS
.
IN/OUT
.
CONNECT TO PC
If the modem cable is not connected make sure that
+ and switch on Dlite.
CLEAR ENTER
CLEAR
to continue the operation or
YES
CONNECT TO PC
My Computer
+ until the message
ENTER
to cancel the operation.
NO
System Setup and Operations
will toggle to ON.
. This file contains all the show and
CONNECT TO PC
Loading Application
DLITE
is
is displayed.
169