Draytek Vigor2762 series User Manual page 646

ap [value]
hello [value]
status
show
mac add [index addr]
mac clear/disable/enable
[index/all]
flush
Example
Example
> wl wds status
Please enable WDS hello function first.
> wl wds hello 1
% <Note> Please restart router after you set the parameters.
> wl wds status
Telnet Command:
Telnet Command:
This command allows you to enable or disable wireless button control.
wl btnctl [value]
Syntax Description
Syntax Description
Parameter
value
Example
Example
> wl btnctl 1
Enable wireless botton control
Current wireless botton control is on
>
Telnet Command:
Telnet Command:
This command is reserved for RD debug. Do not use them.
Telnet Command:
Telnet Command:
This command allows you to configure the external or internal server used by Vigor router
for wireless authentication.
636
wl dual wds security wep 12345
wl dual wds security wpa2psk 12345678
It means to enable or disable the AP function.
Value:
It means to send hello message to remote end (peer).
Value:
It means to display WDS link status for 2.4GHz connection.
It means to display current WDS settings.
add [index addr] – Add the peer MAC entry in Repeater/Bridge
WDS MAC table.
clear/disable/enable [index/all]- Clear, disable, enable the
specifed or all MAC entries in Repeater/Bridge WDS MAC table.
e.g,
wl dual wds mac enable 1
It means to reset all WDS setting.
wl btnctl
wl btnctl
Description
0: disable
1: enable
wl iwpriv
wl iwpriv
wl set8021x
wl set8021x
1 – enable the function.
0 – disable the function.
1 – enable the function.
0 – disable the function.
Vigor2762 Series User's Guide