Draytek Vigor2762 series User Manual page 606

Home path
Example
Example
> usb user add 1 root 1234 R-DLCR /usr
Telnet Command:
Telnet Command:
This command is to configure specified WAN as bridge mode.
Syntax Description Syntax Description
vigbrg set -v [IP version] -w [WAN_idx] -l [LAN_idx] -e [0/1] -f [0/1]
Syntax Description
Syntax Description
Parameter
-v [IP version]
-w [WAN_idx]
-l [LAN_idx]
e [0/1]
f [0/1]
Example Example
> vigbrg set -v 4 -w 1 -l 1 -e 1
[WAN1] IPv4 bridge is enable. Set subnet[LAN1]
Telnet Command:
Telnet Command:
This command can show whether the Vigor Bridge Function is enabled or disabled.
Example
Example
> vigbrg status
%Vigor Bridge Function is enable!
%Wan1 management is disable!
596
L – List directory.
C – Create directory.
R – Remove selected directory.
Set the path (maximum 159 characters) for the USB user profile.
vigbrg set
vigbrg set
Description
Indicate the IP version for the IP address.
4 – IPv4.
6 – IPv6.
WAN_idx – Indicate the WAN interface.
1 – WAN1
2 – WAN2
3 – WAN3
4 – WAN4
LAN_idx – Indicate the LAN interface.
1 – LAN1
2 – LAN2
3 – LAN3
4 – LAN4
Enable (1) or disable (0) the Vigor Bridge for WAN or/and LAN.
Enable (1) or disable (0) the firewall functions.
vigbrg status
vigbrg status
Vigor2762 Series User's Guide