Draytek Vigor2762 series User Manual page 626

% Profile Index : 2
% Profile Name : market
% Username : vigor
% Password : 5678
% Call Direction : Dial-Out
% Type of Server : PPTP
% Dial to : 5.6.7.8
% Remote NEtwork IP : 192.168.1.31
% Remote NEtwork Mask : 255.255.255.0
> vpn trunk lb add comp 1 2
%% Combination VPN Load Balance profile list :
<Index>
Member2(Act
ive)Type
1
2(YES)P
PTP
%% Note: <Active: NO> The LAN-to-LAN Profile is disable or under Dial-
In(Call Di
rection) at present.
====================================================================
% Setting OK.
> vpn trunk bind set 1 y comp 2 192.168.10.1~192.168.10.2
192.168.99.1~192.168.99.254 1~65535 0 OFF
% VPN Load Balance Tunnel Bind Table Index[1] detail:
===========================================================
Action
Trunk Profile(000) Name= comp
Binding Dial Out Index = 2
Binding Src IP
Binding Dest IP
Binding Dest Port
Binding Fragmented
Binding Protocol
>
Telnet Command:
Telnet Command:
This command allows users to enable or disable NetBios for Remote Access User Accounts or
LAN-to-LAN Profile.
vpn NetBios set <H2l/L2l> <index> <Block/Pass>
Syntax Description
Syntax Description
Parameter
<H2l/L2l>
<index>
<Block/Pass>
Example Example
616
< Name >
>
comp
= ACTIVE
= 192.168.10.1 ~ 192.168.10.2
= 192.168.99.1 ~ 192.168.99.254
= 1 ~ 65535
= NO
= ANY Protocol
vpn NetBios
vpn NetBios
Description
H2l means Remote Access User Accounts.
L2l means LAN-to-LAN Profile.
Specify which one will be applied by NetBios.
The index number of the profile.
Pass – Have an inquiry for data transmission between the hosts
located on both sides of VPN Tunnel while connecting.
Block – When there is conflict occurred between the hosts on both
sides of VPN Tunnel in connecting, set it block data transmission of
Netbios Naming Packet inside the tunnel.
< Member1(Active)Type
1(YES)PPTP
> <
Vigor2762 Series User's Guide