Draytek Vigor2762 series User Manual page 632

TX Packets=0, TX Rate(Bps)=0, RX Packets=0, RX Rate(Bps)=0
Primary DNS=0.0.0.0, Secondary DNS=0.0.0.0
PVC_WAN3: Offline, stall=N
Mode: ---, Up Time=00:00:00
IP=---, GW IP=---
TX Packets=0, TX Rate(Bps)=0, RX Packets=0, RX Rate(Bps)=0
PVC_WAN4: Offline, stall=N
Mode: ---, Up Time=00:00:00
IP=---, GW IP=---
TX Packets=0, TX Rate(Bps)=0, RX Packets=0, RX Rate(Bps)=0
PVC_WAN5: Offline, stall=N
Mode: ---, Up Time=00:00:00
IP=---, GW IP=---
TX Packets=0, TX Rate(Bps)=0, RX Packets=0, RX Rate(Bps)=0
Telnet Command:
Telnet Command:
This command allows you to Ping a specified IP to detect the WAN connection (static IP or
PPPoE mode).
wan detect [wan1][on/off/always_on]
wan detect [wan1]target [ip addr]
wan detect [wan1]ttl [1-255]
wan detect status
Syntax Description
Syntax Description
Parameter
on
off
always_on
target
ip addr
ttl
status
Example
Example
> wan detect status
WAN1: always on
WAN2: off
WAN3: off
WAN4: off
WAN5: off
> wan detect wan1 target 192.168.1.78
622
wan detect
wan detect
Description
It means to enable ping detection. The IP address of the target
shall be set.
It means to enable ARP detection (default).
disable link detect, always connected(only support static IP)
It means to set the ping target.
It means the IP address used for detection. Type an IP address in
this field.
It means to set the ping TTL value (work as trace route)
If you do not set any value for ttl here or just type 0 here, the
system will use default setting (255) as the ttl value.
It means to show the current status.
Vigor2762 Series User's Guide