Draytek Vigor2762 series User Manual page 641

isolate [ssid_num lan
member]
Example
Example
> wl config mode 11bgn
Current mode is 11bgn
% <Note> Please restart wireless after you set the channel
> wl config channel 13
Current channel is 13
% <Note> Please restart wireless after you set the channel.
> wl config preamble 1
Long preamble is enabled
% <Note> Please restart wireless after you set the parameters.
> wl config ssid 1 enable dray
SSID
1
% <Note> Please restart wireless after you set the parameters.
> wl config security 1 wpa1x
%% Configured Wlan Security Setting:
% SSID1
%% Mode: wpa1x
%% Wireless card must be reset for configurations to take effect
%% (Telnet Command: wl restart)
Telnet Command:
Telnet Command:
This command allows users to configure basic wireless settings.
wl set [SSID] [CHAN[En]]
wl set txburst [enable]
Syntax Description
Syntax Description
Parameter
SSID
CHAN[En]
txburst [enable]
Vigor2762 Series User's Guide
specified SSID. 0: disable and 1:enable.
upload: It means to configure the rate control for data upload.
The unit is kbps.
download: It means to configure the rate control for data
download. The unit is kbps.
It means to isolate the wireless connection for LAN and/or
Member.
lan – It can make the wireless clients (stations) with remote-dial
and LAN to LAN users not accessing for each other.
member – It can make the wireless clients (stations) with the same
SSID not accessing for each other.
Enable Hide_SSID
1 0
wl set
wl set
Description
It means to type the SSID for the router. The maximum character
that you can use is 32.
It means to specify required channel for the router.
CHAN: The range for the number is between 1 ~ 13.
En: type on to enable the function; type off to disable the
function.
It means to enhance the performance in data transmission about
40%* more (by enabling Tx Burst). It is active only when both sides
of Access Point and Station (in wireless client) invoke this function
at the same time.
0: disable the function.
Name
dray
631