Draytek Vigor2762 series User Manual page 538

msubnet ipcnt [2/3/4] [IP counts]
Syntax Description Syntax Description
Parameter
2/3/4/5/6
IP counts
Example
Example
> msubnet ipcnt 2 15
This setting will take effect after rebooting.
Please use "sys reboot" command to reboot the router.
Telnet Command:
Telnet Command:
This command is used to establish a route between two LAN interfaces.
msubnet talk [1/2/3/4] [1/2/3/4] [On/Off]
Syntax Description
Syntax Description
Parameter
1/2/3/4
On/Off
Example
Example
> msubnet talk 1 2 on
% Enable routing between LAN1 and LAN2!
This setting will take effect after rebooting.
Please use "sys reboot" command to reboot the router.
> msubnet talk
% msubnet talk <1/2/3/4> <1/2/3/4> <On/Off>
% where 1:LAN1, 2:LAN2, 3:LAN3, 4:LAN4
% Now:
%
% LAN1
% LAN2
% LAN3
% LAN4
Telnet Command:
Telnet Command:
528
Description
It means LAN interface.
2=LAN2
3=LAN3
4=LAN4
Specify a total number of IP address allowed for each LAN
interface.
The available range is from 0 to 220.
msubnet talk
msubnet talk
Description
It means LAN interface.
1=LAN1
2=LAN2
3=LAN3
4=LAN4
On – It means to establish a link for the selected LAN with others.
Off - It means to terminate the link.
LAN1 LAN2
V
V V
msubnet startip
msubnet startip
LAN3 LAN4
V
V
Vigor2762 Series User's Guide