Draytek Vigor2762 series User Manual page 464

Telnet Command:
Telnet Command:
This command can display the annex interface of this router.
Example Example
> adsl annex
% hardware is annex B.
% modem code is annex B; built at 01/15,07:34.
Telnet Command:
Telnet Command:
This command is used to add or remove ADSL modes (such as ANNEXL, ANNEXM and ANNEXJ)
supported by Multimode.
adsl automode [add|remove|set|default|show] [adsl_mode]
Syntax Description
Syntax Description
Parameter
Parameter
add
remove
set
default
show
adsl_mode
Example
Example
> Vigor> adsl automode set ANNEXJ
Automode supported :
Vigor> adsl automode default
Automode supported :
Telnet Command:
Telnet Command:
This command can display the allocation for each Bin (Tone) SNR, Gain, and Bits.
adsl showbins [startbin endbin |up]
Syntax Description
Syntax Description
Parameter
startbin
endbin
up
Example
Example
> adsl showbins 2 30
DOWNSTREAM :
-----------------------------------------------------------------------------
454
adsl annex
adsl annex
adsl a utomode
adsl a utomode
Description
Description
Add ADSL mode.
Remove ADSL mode.
Use default settings plus the new added ADSL mode.
Use default settings.
Display current setting.
There are three modes to be choose, ANNEXL, ANNEXM and
ANNEXJ.
T1.413, G.DMT, ADSL2, ADSL2+, ANNEXJ,
T1.413, G.DMT, ADSL2, ADSL2+,
adsl showbins
adsl showbins
Description
The number is between 0 ~ 4092.
The number is between 4 ~ 4095.
Show upstream information.
Vigor2762 Series User's Guide