Draytek Vigor2762 series User Manual page 539

This command is used to configure a starting IP address for DCHP.
msubnet startip [2/3/4] [Gateway IP]
Syntax Description
Syntax Description
Parameter
2/3/4
Gateway IP
Example
Example
> msubnet startip 2 192.168.2.90
%Set LAN2 Dhcp Start IP done !!!
This setting will take effect after rebooting.
Please use "sys reboot" command to reboot the router.
> msubnet startip ?
% msubnet startip <2/3/4> <Gateway IP>
% Now: LAN2 192.168.2.90; LAN3 192.168.3.10; LAN4 192.168.4.10;
Telnet Command:
Telnet Command:
This command is used to configure a starting IP address for PPP connection.
msubnet pppip [2/3/4] [Start IP]
Syntax Description
Syntax Description
Parameter
2/3/4
Start IP
Example
Example
> msubnet pppip 2 192.168.2.250
% Set LAN2 PPP(IPCP) Start IP done !!!
This setting will take effect after rebooting.
Please use "sys reboot" command to reboot the router.
> msubnet pppip ?
% msubnet pppip <2/3/4> <Start IP>
% Now: LAN2 192.168.2.250; LAN3 192.168.3.200; LAN4 192.168.4.200
Telnet Command:
Telnet Command:
This command is used to specify the type for node which is required by DHCP option.
msubnet nodetype [2/3/4][count]
Vigor2762 Series User's Guide
Description
It means LAN interface.
2=LAN2
3=LAN3
4=LAN4
Type an IP address as the starting IP address for a subnet.
msubnet pppip
msubnet pppip
Description
It means LAN interface.
2=LAN2
3=LAN3
4=LAN4
Type an IP address as the starting IP address for PPP connection.
msubnet nodetype
msubnet nodetype
529