Draytek Vigor2762 series User Manual page 581

srv nat trigger setdefault
srv nat trigger view
srv nat trigger n [-<command> <parameter> | ... ]
Syntax Description Syntax Description
Parameter
setdefault
view
n <command><parameter>|
...]
-c[XXX]
-e [0/1]
-p [1/2/3]
-t
-P
-i
-d
-v
Example
Example
> srv nat trigger 1 -c after_dinner
> srv nat trigger 1 -e 1
> srv nat trigger 1 -p 1
> srv nat trigger 1 -t 2000
> srv nat trigger 1 -P 2
> srv nat trigger 1 -i 3000
> srv nat trigger 1 -v
Port Trigger Rule Index:1
Status:Enable
Comment:after_dinner2000
Triggering Protocol:TCP
Triggering Port:2000
Incoming Protocol:UDP
Incoming Port:3000
Telnet Command:
Telnet Command:
This command allows users to view NAT Port Redirection Running Table.
Example
Example
> srv nat status
Vigor2762 Series User's Guide
Description
Set to factory default settings.
Dispaly all of the port triggering settings.
"n" means the rule number.
The available commands with parameters are listed below.
[...] means that you can type in several commands in one line.
Type a comment for such rule if required.
Enable (1) or disable (0) a rule (specified with rule number).
Specify the protocol for such trigger rule.
1 – TCP
2 – UDP
3 - All
Specify the port number (0~65535) for trigger.
Specify the incoming protocol for such trigger rule.
Specify the port number (0~65535) for incoming protocol.
Delete the selected trigger rule.
Display the port trigger settings for specified rule.
srv nat status
srv nat status
571