Table of Contents
Advertisement
3
Wipe off the ink with the wiper filter.
4
Wipe off the ink attached to the cap.
• Hold the bottle with the cap facing upward and
wipe off the ink attached to the cap with a paper
towel or a similar object.
5
Remove the cap from the used ink bottle.
• If you have difficulty removing the cap, use the
tightening jig to remove the cap.
6
Install a new ink bottle by referring to P.1-
12"Installing the Ink Bottles".
• Do not leave ink bottles with the special cap
attached in a place exposed to light for a pro-
longed period of time. Doing so can cause the ink
inside to harden.
When [INK NEAR END] is displayed
The remaining ink level is low. Although you can continue
printing, the machine may run out of ink while printing. We
therefore recommend that you replace the ink bottle as
soon as possible.
If you press the
key in LOCAL mode, you can
view a local guidance that provides information regarding
the bottle that requires replacement.
You can also check the ink bottle lamp to find the bottle to
(
P.1-16)
replace.
If the light-blocking cover comes off, the inside of the tank
is exposed to light, which causes the ink to harden.
If the light-blocking cover comes off, attach it to the tank
as follows:
Wiper filter
(
P.3-27)
If the light-blocking cover comes off
1
Insert one of the lugs on the light-blocking
cover into one of the receiving holes on
the tank.
2
While pressing the light-blocking cover
against the receiving hole into which you
have just inserted the lug, insert the other
lug into the remaining hole on the tank.
Chapter 1 Before Use
1-15
1
2
2
2
2
Advertisement
Table of Contents
