MIMAKI UCJV300-75 Operation Manual page 93

Area where register marks and designs
can be arranged
The placeable range for the register mark and the image
is as follows.
• Set the start position of the register mark at 100 mm or more
from the media front end.
• Set the end position of the register mark at 110 mm or more
from the media rear end.
• When the data is copied by using RasterLink, make sure to
leave a space of 210 mm or larger at the tail end of the sheet.
Type 1
Mark Shape:
Rear
Area where cutting is permitted
Available cutting area
50 mm or more
5mm or more 5mm or more
Front
Type 2
Mark Shape:
Rear
Area where cutting is permitted
Available cutting area
50 mm or more
5mm or more 5mm or more
Front
110mm or 210mm more
20 mm or more
110mm or 210mm +
(register mark length / 2) or
more
20 mm+ (register mark
length / 2) or more
Chapter 4 Cutting Function
No-plotting area around the register
marks
The area around a register mark (from the mark origin to
the mark size area) is a non-plotting area. There must be
no data plotted and no stains in this area; otherwise, the
origin may be detected incorrectly or a mark read error
could occur.
• If the mark origin is detected incorrectly, cutting will
be performed in the wrong area.
register mark: Type 1
No-plotting area
register mark: Type 2
No-plotting area
Incorrect detection example 1
When there is a line outside the register marks
No-plotting
area
Incorrect detection example 2
When the distance between register marks (TP2 and TP1
or TP4 and TP2) is smaller than the mark length (for Type
2)
Space larger
than the mark
length
Mark length
Mark Origin
Mark
Mark length
Mark Origin
Mark origin detected
incorrectly
Space larger
than the mark
length
4
2
2
4-3