Table of Contents
Advertisement
• Even if the cap is removed, the ink does not over-
flow by the internal mechanism.
8
Connect the jig to the port.
• Lift the lid on the front of the carriage and pull out
the jig.
• As with the cap, push the end of the jig into the
port and rotate it clockwise by 30 °.
Lid
9
key
Press the
10
Check inside the transparent tube of the jig
whether ink is being discharged.
• Be sure to discharge until the amount of ink
discharged is constant and there is no air mixing.
After confirming the discharge, please remove the
jig and press the
• After 30 second elapse, ink discharge is
automatically stopped.
If ink is not ejected properly, please "retry".
• While ejecting ink, press the
vigorously for 3 seconds.
• Lift the tube to let the ink inside. If ink remains in
the tube, it may cure.
• If the retry operation is performed continuously
while the jig is connected to one port, air may be
mixed into the head, which may cause nozzle
missing. Terminate the air purge when the ink is
normally discharged.
Cap
Jig
to start air purge .
key to finish.
to eject ink
11
If there are other target ports on the
working head, discharge the ink
continuously.
• Connect jigs and discharge ink as well.
• After purging all target ports of the working head,
select "Finish".
12
Remove the jig on the "Remove the air
purge jig" screen, close the lid of the
carriage and close the front cover.
13
Press the
carriage to the cap position.
• If only one head is selected, cleaning is
automatically performed and it ends.
• If more than one head is selected, Head 2 is
automatically moved to the wiper position.
Purge the target port as in Head 1
Chapter 5 Maintenance
key to move the
5-17
5
2
Advertisement
Table of Contents
