Table of Contents
Advertisement
Chapter 6 Troubleshooting
Message
ERROR 18a
Main PCB V_CORE
ERROR 18c
Main PCB V12
ERROR 15f
HEAD DRIVE HOT
ERROR 171
NEW HEAD CONNECT
ERROR 18a
Main PCB V_CORE
ERROR 18b
Main PCB V1R5B
ERROR 18c
Main PCB V12
ERROR 18e
FLS NOT COMP
ERROR 18f
OFSET START
ERROR 18f
OFSET END
ERROR 19f
LED Connection Error
ERROR 1dc
Station4 PCB V24
ERROR 1dd
Station4 PCB V24-A
ERROR 1e6
PRAM SIZE SHORTAGE
ERROR 201
COMMAND ERROR
ERROR 202
PARAMETER ERROR
ERROR 206
PRINTING MODE
ERROR 304
USB INIT ERR
ERROR 305
USB TIME OUT
6-8
Cause
An error occurred in the power supply of
the main PCB.
COM driver becomes the high tempera-
ture.
New Print Head was recognized.
An error occurred in the power supply of
the main PCB.
An error occurred in the head control.
UVLED PCB not connected.
An abnormality occurred in the power
supply of Station 4 PCB.
Memory size is insufficient.
The machine received some data other
than print data. Or, an error occurred in
the transmitted print data.
An error occurred in the transmitted print
data.
The
machine
received
some
unprintable condition.
An error occurred in the communication
of USB.
Measures
• Turn off the power to the machine and turn it
on after a while.
When displaying again, contact your local
distributor, our sales office, or service center.
• Execute data clear and transmit data again.
• Turn the power on again and transmit the
data.
• Check the USB cable connection.
• Use an interface cable conforming to the
specifications.
• Check the print data output condition of the
RIP software.
data
• Check the profile.
When displaying again, contact your local
distributor, our sales office, or service center.
• Check the USB cable connection.
• Connect the USB cable again.
• Turn the power on again and transmit the
data.
• Use an interface cable conforming to the
specifications.
Advertisement
Table of Contents
