Table of Contents
Advertisement
Precautions in Use
CAUTION
Handling of the power cable
• Connect to a socket-outlet with determinate
polarity.
• For PLUGGABLE EQUIPMENT, the socket-
outlet shall be installed near the equipment
and shall be easily accessible.
• Unplug the cord from the wall outlet and
remove dust from the power plug periodically,
at least once a year. Failure to do so may
result in fire or electric shocks.
• Do not use the machine unless it is connected
to a power supply that satisfies the displayed
voltage condition.
• Check the voltage of the wall outlet and the
capacity of the circuit breaker before you plug
the power cords. Plug each power cord to
different outlet that has independent circuit
breaker If you plug more than one power cord
to wall outlets that share the same circuit
breaker, the power may be cut off by the
breaker.
Power supply
• Leave the breaker turned ON.
• Do not turn off the main power switch on the
right side of this machine.
Ultraviolet (UV) light
• Some leakage of ultraviolet light occurs
around the LED UV unit. Exposing skin and
eyes
to
ultraviolet
inflammation and skin cancer. Even if weak
ultraviolet light does not cause inflammation,
chronic disorders could develop due to
repeated exposure. Avoid exposing your skin
and eyes to ultraviolet light.
• Visual impairments that can occur as a result
of exposure to ultraviolet light include acute
disorders such as pain or excess tearing in
response to foreign matter, and chronic
disorders such as cataracts. When using this
machine, be sure to wear gloves, long-sleeved
clothing, a visor over your face, and the
shaded glasses that are included with the
machine.
Notes on the LED UV unit
• When handling the glass on the bottom of the
LED UV unit, be sure to wear the included
gloves. Never touch the glass with your bare
hands. Otherwise, the UV ink curing level may
drop significantly. If the glass becomes dirty,
wipe it with clean gauze moistened with
alcohol. (Do not use alcohol for cleaning the
exterior cover, or the paint will peel off.)
• The LED UV performance and service life are
significantly affected by the UV irradiation and
UV power supply units that are used. Only use
UV devices that are recommended by
Mimaki.Mimaki shall bear no responsibility for
any trouble due to the use of UV devices other
than those that are recommended.
light
could
cause
CAUTION
Be careful with the movable parts
• Do not touch the rolling grit roller. Otherwise,
you could hurt your fingers or tear off your
finger nails.
• Keep your head and hands away from any
moving
parts
during
operation. Otherwise, your hair could become
caught in the machine. Wear proper clothes.
(Do not wear loose-fit clothes or accessories).
Bind a long hair.
Caution with cutters
• The cutter blades are very sharp. Do not touch
them.
• Do not shake or swing the cutter holder.
Otherwise, the blade may come off.
Hot parts
• The LED UV unit is very hot. Before
performing maintenance work, wait until the
temperature has dropped sufficiently after the
LED UV unit has been turned off.
• If touching hot parts is unavoidable, be sure to
wear heat-insulating gloves to protect your
hands.
Cautions on Installation
CAUTION
A place exposed to direct
sunlight
A place that vibrates
A place where the
temperature or humidity
varies significantly
• Use the
machine under
the following
environmental
conditions:
• Operating
environment:
20 to 30 °C
(68 to 86 °F)
35 to 65 % (Rh)
Safety Precautions
cutting
(plotting)
On an inclined surface
A place exposed to direct
air flow from an air
conditioner
Around a place where fire
is used
1
2
2
2
2
2
1
x
Advertisement
Table of Contents
