How To Install A Ballpoint Pen - MIMAKI UCJV300-75 Operation Manual

Chapter 2 Basic Operation
Protruding amount of the cutter blade
Protruding amount
of the cutter blade
Film
Base paper
Amount of cutting=
• However, When Filem is thinner than
Base Paper
For reference: the protruding amount of the cutter blade =
0.2 to 0.5 mm
(Replace the blade when it is blunt.)
• Adjust the blade pressure so that the cutter may
leave a little bit of cutter track on the sheet.
• In case the sheet thickness is thinner than the film
thickness, which may not provide correct cutting
quality, change the protruding amount of the blade
and you may get a better result.
How to install the cutter holder
• Install the cutter holder to the tool holder of the
carriage.Be sure to insert the cutter holder all the
way in the tool holder.
1
In LOCAL mode, press
(>>)
• The cutting menu appears.
2
Press
and then press the
• The cutter unit moves to the left end of the
machine.
3
Rotate the knob to loosen the holder
presser.
Holder presser
Knob
4
Insert the cutter holder into the tool holder.
• Push the brim of the cutter holder against the tool
holder.
2-24
Amount of cutting
(Film thickness + Base paper
thickness)
2
(MENU)
.
, select "TOOL REPLACE",
key.
• Press the brim of the cutter holder with the holder
presser.
Brim
Holder presser
5
Fix the cutter holder.
• Turn the knob of the tool holder clockwise, and fix
it securely.
Knob
• Fix the cutter holder firmly. If not, accurate and
high-quality cutting will not be achieved.
6
Press the key.

How to Install a Ballpoint Pen

• When you want to use a commercially available
ballpoint pen, you must use the pen of 8mm to
9mm in diameter. Image quality may depend on
the pen.
(Recommended ballpoint pen: the one available
from Pentel Co., Ltd. with the product No.: K105-
A, K105-GA)
• Regarding such ballpoint pens as shown below,
the pen inclines to touch the cover when held by
the pen adapter. (A pen that has a contoured body
or a pen that has a lug or uneven surface)
A pen that has a contoured
body
1
Put the cap on the pen adapter.
• Use the cap to adjust the pen height.
A pen that has a lug or
uneven surface