MIMAKI UCJV300-75 Operation Manual page 91

This chapter
describes about cutting function.
Cut Out Data with Register Mark ................... 4-2
The Flow of Cutting out the Registered
Data............................................................. 4-2
Enter register mark detection mode ............ 4-2
Precautions for inputting data with register
marks .......................................................... 4-2
Settings for Detecting register marks .......... 4-5
ID Cut .......................................................... 4-6
About CUTTING MENU ............................... 4-11
Cutting MENU table .................................. 4-12
Setting the CUT MODE................................ 4-13
Perform Multiple Cuttings (Copy function) ... 4-13
Cutting Function
SETUP SUB MENU .....................................4-14
Make the media without uncut area
(OVER CUT function) ................................ 4-15
Other SETUP SUB MENU......................... 4-15
SETUP RESET.......................................... 4-16
Maintenance Function..................................4-17
Maintenance of Mark Sensor..................... 4-17
Perform SAMPLE CUT to Find out the
Cause of Cutting Error. .............................. 4-19
Cutting a Medium into Multiple Pieces with
a Certain Length ........................................ 4-19
Cutting out Data without Register Marks
(PC ORIGIN OFFSET) .............................. 4-20
Setting the Scale Adjust............................. 4-21
Chapter 4