Table of Contents
Advertisement
Chapter 1 Before Use
Installing the Ink Bot-
tles
1
Take out an ink bottle and gently shake it
from side to side at least 20 times.
• While wearing gloves, hold the cap of the ink
bottle tightly with a paper towel or a similar object,
and then gently shake the bottle from side to side
at least 20 times to let the ink flow inside the
bottle.
• Confirm that the cap is firmly closed, and then
gently shake the bottle.
• Remember to shake the bottle gently. Shaking the
bottle violently can cause the ink to leak out.
• When the remaining ink is low, tilt the ink bottle all
the way to the right and left until the bottle is in the
upright position to ensure that the ink inside the
bottle is thoroughly mixed.
Hold the cap of the ink bottle tightly with a paper
towel, and gently shake the ink bottle.
Repeat
2
Remove the cap from the bottle.
1-12
• If, after removing the cap from the bottle, you find
that the bottle opening has a seal attached to it,
use a cutter to open the seal. Cut the seal as
shown in the figure below so that the seal is
divided into eight parts, and then bend the cut seal
toward the inside of the bottle.
• Make sure that the cut seal is bent securely toward
the inside of the bottle. If the cut seal is not bent
securely, an ink supply shortage can occur.
•
Cut the seal as shown in the figure to
the left so that the seal is divided into
eight parts, and then bend the cut
seal toward the inside of the bottle.
3
Screw the special cap onto the ink bottle.
(1) Screw the special cap onto the bottle.
Cap B
Special cap
Advertisement
Table of Contents
