Table of Contents
Advertisement
Chapter 4 Cutting Function
Detect operation
Minus
direction
Plus direction
Mark length
Scan in the Y direction
Plus
direction
Scan in the X direction
1
Scan in the X direction (plus direction) to
detect the line.
• The buzzer sounds when the line is detected. If
the line is not detected, the buzzer does not
sound.
2
Scan in the X direction (minus direction) to
detect the line.
3
Scan in the Y direction (plus direction) to
detect the line.
4
Scan in the Y direction (minus direction) to
detect the line.
5
Follow the Steps 1 to 4, and confirm if the
buzzer sounds 4 times.
• When the detection behavior completes
successfully, the buzzer sounds 4 times.
• If the buzzer does not sound, contact our service
desk or your local distributor for service.
4-18
Minus
direction
Correct the light pointer position
If the machine fails to recognize any register mark
properly, the possible cause is an error in the positional
relationship between the MARK sensor and the light
pointer. In this case, adjust the position of the light pointer.
1
Install a pen in the tool holder
2
Load the copy paper.
3
Press the
key in LOCAL.
• The cutting MENU will be displayed.
4
Press
(>>) .
5
Press
to select
"MAINTENANCE", and press the
key.
6
Press
to select "MARK
SENSOR", and press the
7
Press
to select "POINTER OFS",
8
Press the
• A 10 mm by 10 mm cross pattern will be cut.
• The light pointer turns on and moves to the center
of the cross pattern.
9
Press
pointer position so that the center of the
light pointer is in alignment with the center
of the cross pattern.
10
Press the
• The screen returns to LOCAL.
• The value registered in the [POINTER OFS] is not
initialized even by executing the "SETUP RESET"
(
P.4-16).
(MENU)
(>>)
key.
key.
to adjust the light
key.
Advertisement
Table of Contents
