Table of Contents
Advertisement
Message
ERROR B0A
CTC PCB Vpow
ERROR B0B
CTC PCB V24
ERROR B0C
CTC PCB V5R0
ERROR B0D
CTC PCB V3R3
ERROR B0E
CTC PCB V2R5
ERROR B0F
DIO PCB Uvpow
ERROR B19
Station4 PCB V36
SYSTEM HALT
Message
SYSTEM HALT (*)
000 : MESSAGE
SYSTEM HALT (*)
406 : WIPER ORG
Cause
Power supply voltage error on CTC
PCB.
Power supply voltage error on UV-DRV
PCB.
An error occurred in the power supply of
the STATION IV PCB.
• Turn off the power to the machine and turn it on after a while.
When displaying again again, check the number and contact your local distributor, our
sales office, or service center. ("000" is the error No.)
• Perform cleaning around the wiper.
• Turn off the power to the machine and turn it on after a while.
When displaying again again, check the number and contact your local distributor, our
sales office, or service center.
Chapter 6 Troubleshooting
Measures
• Turn off the power on the machine and turn it
on after a while.
When displaying again, contact your local
distributor, our sales office, or service center.
Measures
1
2
2
2
2
6
6-13
Advertisement
Table of Contents
