Table of Contents
Advertisement
Chapter 4 Cutting Function
Size of and distance between register
marks
The size (Y) of a register mark suited for the distance (X)
between the marks is as shown below.
If the mark size (Y) is too small relative to the distance (X),
the marks may not be detected correctly. Be sure to
prepare appropriately sized register marks.
X
200 max.
500 max. 1000 max. 2000 max. 2001 min.
Y
5 to 40
8 to 40
Distance between register marks for
copied designs
For Type 1 register marks, the distance between the
marks must be no shorter than two times the mark length
and no longer than 1000 mm. For Type 2 register marks,
the distance between the marks must be no shorter than
the mark length and no longer than 1000 mm.
register mark: Type 1
register mark: Type 2
4-4
15 to 40
25 to 40
35 to 40
Units (mm)
Distance between register
marks =
Between mark length (X)
x2 and 1000 mm
Distance between
register marks =
Between mark length
(X) and 1000 mm
Recommended size of the area defined
with a set of four register marks
It is recommended that the size of the area defined with a
set of four register marks is in the range of A4 size (210
mm x 297 mm) to A3 size (297 mm x 420 mm).
When printing register marks
continuously
When printing register marks continuously, set one side of
the register mark to 8 mm. If 8 mm or shorter register
marks are detected continuously, glitches might occur in
the machine.
Mark color
Marks must be printed in black against a white
background.
register marks will not be detected correctly if the
background is not white or the marks are not black.
Blurred marks
If a mark is blurred, the mark origin might be detected
incorrectly, thus resulting in deviated cutting.
A4 size (210mm
x 297mm) to A3
size (297mm x
420mm)
8 mm or more
Advertisement
Table of Contents
