Table of Contents
Advertisement
Chapter 4 Cutting Function
Setting of Detecting the Registration Marks
1
Press the
2
Press
3
Select "MARK DETECT", and then press the
4
Press the
5
Press
Item
DETECT AREA
SCAN DIR.
FEED DIR.
OFFSET X
About [DETECT AREA].
• SCAN DIRECTION, FEED DIRECTION, OFFSET X are as following.
Scan path for Auto MARK DETECT
4-8
(MENU)
(>>)
to select "CUTTING", and then press the
key.
to make settings for the following items, and then press the
Value
You can configure various settings for the register mark
-
operation.
Configure the detection width for the scanning direction. The
register mark is detected while scanning is performed
bidirectionally at the set detection width.
DEFAULT,
• DEFAULT:
0 cm,
5 cm to the
• 0 cm:
machine width
• 5 cm to the machine width: The register mark is detected with the
10 cm to 50 cm
Set the detection distance in the feed (media feed) direction.
0 cm to 100 cm
Set the Detection start position after the ID Cut.
keys in LOCAL
key
key.
Set value
The register mark is detected at half the
media width.
The register mark is detected only in
the feed (media feed) direction.
set width.
Detection start position
SCAN DEIRECTION
The ID Cut end
position for the
data
immediately
before
key
[Rear]
FEED
DIRECTION
OFFSET X
[Front]
Advertisement
Table of Contents
