MIMAKI UCJV300-75 Operation Manual page 113

This chapter
describes the items required to use this machine more comfortably, which are the meth-
ods for the daily care, the maintenance of the ink cartridges etc.
Maintenance .................................................. 5-2
When the Machine Is Not Used for a Long
Time ............................................................ 5-2
Precautions for Maintenance ...................... 5-2
Cleaning the Exterior Surfaces ................... 5-2
Cleaning the Platen..................................... 5-2
Cleaning the Media Sensor......................... 5-3
Cleaning the Media Press ........................... 5-3
About MAINTENANCE MENU....................... 5-4
MAINTENANCE MENUs table .................... 5-5
Maintaining the
Capping Station ............................................. 5-6
Cleaning the Wiper and Cap ....................... 5-6
Cleaning the mist filter ................................. 5-7
Clean the NCU ............................................ 5-8
Washing the Head Nozzle........................... 5-9
Cleaning of ink discharge passage ............. 5-9
When the Machine Is Not Used for a Long
Time .......................................................... 5-10
Cleaning the Ink Head and the Area
around It....................................................... 5-12
Nozzle Recovery Function ........................... 5-13
Reset the set value ................................... 5-14
Eliminate Ink Over Flow .............................. 5-14
Maintenance
Automatic Maintenance Function.................5-15
Setting the Refreshing Intervals................. 5-15
Setting the Cleaning Intervals and Type.... 5-15
INK FILLING.................................................5-16
AIR PURGE ............................................... 5-16
Replacing consumables ...............................5-18
Replacing the wiper ................................... 5-18
Replacing the mist filter .............................5-18
If a Waste Ink Tank Confirmation Message
Appears ..................................................... 5-19
Replace the waste ink tank with another ... 5-19
Replacing the waste ink tank before the waste
ink tank confirmation message is
displayed.................................................... 5-20
Replacing the Cutter Blade........................ 5-20
Replacing and Adjusting the Cutter Blade ...5-21
Replacing the cutter................................... 5-21
Adjusting the Cutter Blade ......................... 5-22
Replacing cutters other than supplied one 5-22
Adjusting blade edge of cutters other than
supplied one .............................................. 5-22
Chapter 5