MIMAKI UCJV300-75 Operation Manual page 39

Media size and grit rollers (UCJV300-130)
The grit rollers to be used vary depending on the size of the media.
• To feed the media smoothly, select the appropriate grid roller positions so that the media can be held at equally spaced
intervals.
• When the grid rollers to be used are determined, adjust the pinch roller unit by referring to "P.2-5 「How to adjust the pinch
roller」".
• You can use any number of pinch roller units from 2 to 6.
• The pinch rollers at the left and right ends of the media must be located within 10 cm and 2 cm of the ends of the media,
respectively. If they are positioned further from the ends of the media, some part of the media remains uncut.
Determine the grid rollers to be used according to
the size of the media.
GR10 GR10 GR9 GR9 GR8 GR8 GR7 GR7
1328 ~ 1371mm 1328 ~ 1371mm
1212 ~ 1272mm 1212 ~ 1272mm
1032 ~ 1092mm 1032 ~ 1092mm
1252 ~ 1312mm 1252 ~ 1312mm
1136 ~ 1196mm 1136 ~ 1196mm
956 ~ 1016mm 956 ~ 1016mm
1164 ~ 1224mm 1164 ~ 1224mm
1048 ~ 1108mm 1048 ~ 1108mm
868 ~ 928mm 868 ~ 928mm
Chapter 2 Basic Operation
The right end of the media should
come within this range.
GR6 GR6 GR5 GR5 GR4 GR4 GR2 GR2
GR3 GR3 GR1 GR1
732 ~ 792mm 732 ~ 792mm
576 ~ 644mm 576 ~ 644mm
362 ~ 422mm 362 ~ 422mm
241 ~ 301mm 241 ~ 301mm
656 ~ 716mm 656 ~ 716mm
500 ~ 568mm 500 ~ 568mm
286 ~ 346mm 286 ~ 346mm
165 ~ 225mm 165 ~ 225mm
568 ~ 628mm 568 ~ 628mm
414 ~ 480mm 414 ~ 480mm
198 ~ 258mm 198 ~ 258mm
85 ~ 137mm 85 ~ 137mm
2
2
2
2
2
GR: Grit roller
2-7