Windows Domain Configuration - Quantum DXi4500 User Manual

Chapter 5: DXi4500 Configuration
NAS & OST Configuration
Windows Domain
Configuration
72
Note: If you are using Network Segmentation, you must use
the Data IP address when registering a storage server.
b Configure logical storage units.
4 Register source and target storage servers with NetBackup.
5 Configure source and target disk pools respectively from the storage
servers registered in step 4 above.
6 Backup the required data set (refer to the NetBackup
documentation for more information).
7 Once the backup is successfully completed, wait for the backup
image to be completely deduplicated at the source DXi system.
8 Select the backup image from the Catalog in the NetBackup
Administration console > NetBackup Management. Right-click the
image and start a "duplicate" operation. This will open a
duplication window showing the default target storage units and
other options. Change the target storage unit appropriately and
continue with the copy. Repeat this for all the images to be
replicated by searching for the required images using the search
criteria in the Catalog.
To check the status of the duplicate operation, read job details in
Activity Monitor from the NetBackup Administration Console.
Use the Windows Domain page to join a Samba server to a Windows
workgroup or a Windows domain.
Note: Ensure that your system has the date and time set correctly and
is in sync with your domain controller.
To configure Windows domain information:
1 From the NAS & OST page, click the Windows Domain tab.
The Windows Domain page displays (see Figure 25).
Quantum DXi4500 User's Guide