Quantum DXi4500 User Manual page 109

Quantum DXi4500 User's Guide
network traffic that can be used on that segment. The three types of
network traffic are:
• Replication traffic - This segment is be used exclusively for
replication data movement
• Management traffic - This segment is be used exclusively for
DXi4500 remote management (Web page access)
• Data traffic - This segment is used exclusively for NAS data
movement
Each network segment has its own network interface (IP address,
network mask, and default gateway). In this way, the segment is
separated from other network segment traffic.
Note: Print out Table 17
configuration information for your configuration.
Using Round Robin (Mode 0) With a Dell or CISCO Switch
If you are using the Round Robin (Mode 0) option and you have a Dell
or CISCO switch, then the ports that connect to the DXi4500 must be
bonded.
For example, specify the following settings from the switch CLI:
• Interface Ethernet - If both ports connect to the same switch, set
X X
to 1/g where
replace "1" with the correct ID number (2 or 3).
• Switchport mode - Set to trunk.
• Channel-group 1 mode - Set to on.
Configuring the Network on a DXi4500
To configure the network on the DXi4500:
1 From the Network page, click the Segmentation and Bonding tab.
The Network Segmentation and Bonding page displays (see
Figure 29).
Chapter 5: DXi4500 Configuration
on page 91 to gather the network
is the port number. If there two or more switches,
Network Configuration
87