Setting Up The Source Dxi System; Figure 75 Target Role General Page - Quantum DXi4500 User Manual

Figure 75 Target Role General
Page
Setting Up the Source
DXi System
Quantum DXi4500 User's Guide
2 From the Replication page, click the Target Role tab.
The Target Role General page displays (see
3 Enter the Host Names or IP Address for the replication source and
click Add. Up to 10 sources can be defined.
Entering the host names or IP addresses of the replication source
systems on the target system allows the target to receive replicated
data from these sources.
Once you have added the source system hostname or IP address to the
target system, you must add the target system hostname or IP address
to the source system. The source system can only replicate data to one
target.
Note: You must configure the target system prior to configuring the
source. If the target system is not configured first, you will not
be able to designate the replication target.
1 Access the remote management pages on the source system.
Chapter 11: Implementing a Data Replication Plan
Setting Up Data Replication
Figure 75).
181