Romes Mode - R&S TSMA6 Series User Manual

®
R&S TSMA6
4. Press "Submit".
The R&S TSMA6 is switched into "NESTOR" mode. In the status bar, the entry is
"Changing mode of operation in progress...".
The mode switch is finished when the status bar indicates "No error". The scanner
state LED starts blinking rapidly.
NESTOR Probe mode
1. On the "Mode" tab, select "NESTOR Probe" mode.
2. Press "Submit".
The R&S TSMA6 is switched into "NESTOR Probe" mode. In the status bar, the
entry is "Changing mode of operation in progress...".
The mode switch is finished when the status bar indicates "No error". The scanner
state LED starts blinking rapidly.
The NESTOR measurement is started and controlled from the host PC.
For more details about the R&S NESTOR configuration and usage, refer to the user
documentation for R&S NESTOR.

6.3.5 ROMES Mode

The ROMES mode is only displayed if the ROMES setup has been executed (see
Chapter 7.2.4, "R&S ROMES
General
In the "ROMES" mode, the ROMES software is hosted on the R&S TSMA6 and the
selection of a valid workspace file is required.
In this mode, ROMES software starts with the configured workspace file.
Prerequisites
●
A ROMES license dongle must be connected to a USB port of the R&S TSMA6.
●
To control a ROMES measurement via IP from an external host PC, the ROMES
option ROMES4RCO is required.
●
After the installation, R&S ROMES must be started first time manually via the pro-
gram icon. Then the required directory structure is created on the R&S TSMA6 and
the workspace file can be selected via web-GUI (see
space Files (NESTOR,
To use the R&S TSMA6 with R&S ROMES, the following steps must be performed.
1. In the web GUI, set the "Mode of Operation" to "ROMES" and press "Submit".
User Manual 4900.8057.02 ─ 06
Setup", on page 75) .
ROMES)", on page 42).
Configuring the R&S TSMA6
Measurement Modes
Chapter 6.4, "Import of Work-
41