Table of Contents
Advertisement
Connectivity Test
3. Connect the Connectivity Test radio to a USB cable. The USB driver is required. Do not use a USB
hub. This driver can be found in the following directory:
<INSTALL DIR>\Freescale\Drivers
The BeeKit CD image is available from the Freescale ZigBee web site at
www.freescale.com/zigbee.
4. See
Section 1.3, "UART/USB Virtual COM Port Setup"
virtual COM port for this application.
3.3
Starting the Connectivity Test
To start the connectivity test, perform the following tasks:
1. Configure the Com Port as shown in
2. Connect each board to a USB cable and a USB port (one PC for each board) and ensure it is enabled
as shown in
Section 3.2, "UART/USB Virtual Com Port
3. Reset both boards.
The terminal appears as shown in
1. Press any key and the following text appears.
_______________________________________
|
|
Connectivity Test Interface
|______________________________________|
1 - CHANGE CHANNEL
2 - ADJUST OUTPUT POWER
3 - SELECT TEST MODE
4 - ADJUST CLOCK SETTINGS
Note: Case sensitive.
Please select an option:
MC1322x SMAC Demonstration Application User's Guide, Rev. 1.3
3-4
Section 3.2, "UART/USB Virtual Com Port
Figure
3-5.
Figure 3-5. Starting the Connectivity Test
|
|
for information about how to set up a
Setup".
Freescale Semiconductor
Setup".
Advertisement
Table of Contents
