Table of Contents
Advertisement
Generating an SMAC Application and Port Configuration
5. Modify the project properties as shown in
Component
Security Enabled
Promiscuous Mode
Security Type
Security Default KEY0
Security Default KEY1
Security Default KEY2
SMAC
Security Default KEY3
Security Default COUNTER0 Less Significative 32 bit Word of the 128 bits to be used as initial
Security Default COUNTER1 Second Significative 32 bit Word of the 128 bits to be used as
Security Default COUNTER2 Third Significative 32 bit Word of the 128 bits to be used as
Security Default COUNTER3 More Significative 32 bit Word of the 128 bits to be used as
Target hardware
LCD Enabled
Default SCI Port
PLM
MCU Version
Default Channel
Output Power
Baud Rate
OTAP Enabled
App
OTAP Request Code
OTAP Device Id
MC1322x SMAC Demonstration Application User's Guide, Rev. 1.3
1-4
Table
Table 1-1. Software Component Properties
Property
Enables the security Module to automatically encrypt the
information sent and received.
If set to true, the SMAC Code Bytes are not sent prior to the
message.
This is the security engine used if the security enabled property
is true.
Less Significative 32 bit Word of the 128 bits to be used as key
on the ciphering engine.
Second Significative 32 bit Word of the 128 bits to be used as
key on the ciphering engine.
Third Significative 32 bit Word of the 128 bits to be used as key
on the ciphering engine.
More Significative 32 bit Word of the 128 bits to be used as key
on the ciphering engine.
counter on the ciphering engine.
initial counter on the ciphering engine.
initial counter on the ciphering engine.
initial counter on the ciphering engine.
Allows board selection.
Includes support for LCDs.
Selects the SCI port. Freescale ZigBee boards usually have
SCI Port 1 connected to a DB9 connector and SCI port 2
connected to a USB connector.
Can select either MC13224 or MC13226.
Default starting channel in the application.
Initial power output configuration.
Baud rate to be set at the default SCI port for this application
Enables the OTAP Module to allow over the air programming of
the application.
If the OTAP Module is enabled the application will switch to
OTAP mode when this OTAP Request Code is received.
This ID distinguishes between different devices identified by an
OTAP Programmer.
1-1.
Description
Freescale Semiconductor
Advertisement
Table of Contents
