Table of Contents
Advertisement
Repeater Demonstration
Dropped
The number of frames that has been received but not retransmitted. This is used
on the NORMAL mode. Detail about Normal, Dummy, and Sniff modes are
covered later in this section.
2. Type "0" (zero) to reset statistics.
3. Type "r" to show repeater's menu.
4. Type "m" to switch between repeater's operational modes: NORMAL, DUMMY and SNIFF.
Normal
The application receives a message and wait "Delay Length" to receive other
messages before retransmitting. If a second message is received, the original
received packet is dropped and not retransmitted.
Dummy
Anything that is received is retransmitted as soon as possible.
Sniff
The application shows the messages received and does not retransmit anything.
5. Type "p" to change radio's output power. The power increases each time "p" is typed until the
maximum value is reached. When the maximum value is reached, it resets to the minimum value
and begins increasing again. See
6. Type "d" to change the "Delay Length" value. See
MC1322x SMAC Demonstration Application User's Guide, Rev. 1.3
8-6
Figure
8-9.
Figure 8-9. Power output adjustment
Figure
Figure 8-10. Change Delay Length
8-10.
Freescale Semiconductor
Advertisement
Table of Contents
