Loading The Connectivity Application - NXP Semiconductors MC13224V User Manual

Connectivity Test
Initial State Initial State
Press SW1 Press SW1
Press SW1 Press SW1
The functionality of the application could vary according with the selected board. Boards with the serial
port and push buttons support both interfaces, however for boards without serial port or without push
buttons only one interface is possible.
The following sections describe using the serial interface.
3.1

Loading the Connectivity Application

Prior to loading the Connectivity application, the Connectivity Test application must be generated using
BeeKit using the steps shown in
1. Open the
[Solution Name].eww
2. Select Connectivity Test and load this application into two boards as shown in
"Loading Applications Into a Board Using the JTAG J-Link ARM
MC1322x SMAC Demonstration Application User's Guide, Rev. 1.3
3-2
Press SW1 Press SW1
Reset Reset
Channel Channel
Fine Tune Fine Tune
Coarse Tune Coarse Tune
Figure 3-1. Selecting the Application Mode
Chapter 1, "Generating an SMAC Application and Port
file as shown in
Figure 3-2. My Solution EWW File Location
Power Power
Press SW1 Press SW1
Test Test
Press SW1 Press SW1
Bulk Capacitor Bulk Capacitor
Figure 3-2.
Debugger".
Configuration":
Section 1.1,
Freescale Semiconductor