Table of Contents
Advertisement
Over The Air Programmer Demonstration
At this point the OTA Programmer has stored a new application that can be used to reprogram any
application with the OTAP option enabled. To program the new application to a board with OTAP
enabled, see
Section 10.5, "Transmitting the New Image to the OTAP-enabled
10.4
Downloading an OTAP-enabled Application
The example in this section uses the Accelerometer demonstration to show how to enable the OTAP option
in a device.
To make a new Beekit application with the OTAP option enabled, perform the following tasks:
1. Launch Beekit and click on File -> Select Codebase and choose the "Beekit ARM7 SMAC
Codebase 1.0.0" codebase as shown in
2. Click on File -> New Project.
3. Select the Accelerometer application and choose a name for the solution. In this case the solution
name chosen was Accel as shown in
MC1322x SMAC Demonstration Application User's Guide, Rev. 1.3
10-6
Figure
10-8.
Figure 10-8. Select SMAC Codebase
Figure
10-9.
Board".
Freescale Semiconductor
Advertisement
Table of Contents
