NXP Semiconductors MC13224V User Manual page 20

Generating an SMAC Application and Port Configuration
c) Scroll to the Ports label and expand the tree by clicking the "+" sign. This shows the COM ports
in the system.
d) As shown in
USB Serial Port (COM7).
3. If the COM port chosen is not a port numbered between Ports 1-10, then perform the following
tasks:
a) Double click on USB Serial Port in the Device Manager window. The Properties window
appears.
b) Select the Port Settings tab, and then click on the Advanced button.
c) Go to the COM Port Number drop down menu and select a COM port between 1-10 that is not
already in use.
d) Open the Windows System Properties window using Start->Settings->Control Panel->System.
Select the Hardware tab, and click the Device Manager button. The Device Manager window
appears as shown in
e) Check to ensure the required port appears.
f) Close the Device Manager window.
4. Proceed to generating the project in BeeKit as described in the appropriate application chapter.
MC1322x SMAC Demonstration Application User's Guide, Rev. 1.3
1-10
Figure 1-16, the COM Port chosen by the system is titled
Figure 1-16.
Freescale Semiconductor