Table of Contents
Advertisement
The
Low Power Bell Tx.bin
[Project Directory]\Release\Exe\
5. Use the JTAG interface to load the
Low Power Bell TX. Connect the JTAG interface to the board, then click the Debug button at the
IAR Embedded Workbench IDE.
6. Choose the "Low Power Bell RX" tab.
7. Repeat Steps 3 and 4.
The
Low Power Bell RX.bin
[Project Directory]\Release\Exe\
8. Use the JTAG interface to load the
Low Power Bell RX. Click the IAR Debug button to download the application to the board.
9. Reset both boards.
Pressing SW1 on the Low Power TX board sounds the buzzer on the Low Power Bell RX board.
MC1322x SMAC Demonstration Application User's Guide, Rev. 1.3
Freescale Semiconductor
file is located at the following directory location:
Low Power Bell TX
file is located at the following directory location:
Low Power Bell RX
Low Power Bell Demonstration
application on the board being used as the
application on the board being used as the
5-3
Advertisement
Table of Contents
