NXP Semiconductors MC13224V User Manual page 88

Over The Air Programmer Demonstration
4. Once the OTAP Programmer Board found a device, press the SPACE Bar on the keyboard. The
OTAP Programmer shows the device address (ID) in the serial terminal as shown in
In this case the device address is 0x02. If more OTAP-Enabled devices were found, press the
SPACE Bar on the keyboard to see the device IDs.
5. Press "L" on the keyboard and the OTAP Programmer flashes the device over the air. Users must
wait for the Program Success message to appear in the serial terminal window and not press any
buttons on the OTAP Programmer Board or on the device being flashed. The Program Success
message is shown in
MC1322x SMAC Demonstration Application User's Guide, Rev. 1.3
10-10
Figure 10-14. OTAP Programmer Shows Device's ID
Figure 10-15.
Figure 10-15. Device Programming Success
Figure 10-14.
Freescale Semiconductor