10.5
Transmitting the New Image to the OTAP-enabled Board
Users must have an OTAP Programmer board running with a valid
OTAP-enabled application running. This example uses the Accelerometer Demonstration application.
There are two options for users to FLASH the device over the air:
•
Serial Interface
(Section 10.5.1, "Using the Serial
•
LCD Interface
(Section 10.5.2, "Using The LCD
10.5.1
Using the Serial Interface
1. Press the Reset button on the OTAP Programmer Board.
2. Press SW2 on the OTAP Programmer Board. The serial terminal displays text as shown in
Figure
10-12.
3. Press "P" on the keyboard to search for devices to program. The serial terminal appears as shown
in
Figure
10-13.
MC1322x SMAC Demonstration Application User's Guide, Rev. 1.3
Freescale Semiconductor
Figure 10-12. OTAP Programmer Start Message
Figure 10-13. OTAP Programmer Found a Device
Over The Air Programmer Demonstration
file image and a device with an
.srec
Interface")
Interface")
10-9