Mitsubishi Electric MR-J4-_GF Instruction Manual page 8

Please dispose a servo amplifier, battery (primary battery) and other options according to your local laws and
regulations.
EEP-ROM life
The number of write times to the EEP-ROM, which stores parameter settings, etc., is limited to 100,000. If
the total number of the following operations exceeds 100,000, the servo amplifier may malfunction when the
EEP-ROM reaches the end of its useful life.
Write to the EEP-ROM due to parameter setting changes
Write to the EEP-ROM due to device changes
Write to the EEP-ROM due to point table changes
STO function of the servo amplifier
When using the STO function of the servo amplifier, refer to chapter 13 of "MR-J4-_GF_(-RJ) Servo Amplifier
Instruction Manual (Motion Mode)".
For the MR-J3-D05 safety logic unit, refer to app. 5 of "MR-J4-_GF_(-RJ) Servo Amplifier Instruction Manual
(Motion Mode)".
Compliance with global standards
For the compliance with global standards, refer to app. 4 of "MR-J4-_GF_(-RJ) Servo Amplifier Instruction
Manual (Motion Mode)".
«About the manual»
You must have this Instruction Manual and the following manuals to use this servo. Ensure to prepare
them to use the servo safely.
Relevant manuals
MELSERVO MR-J4-_GF_(-RJ) Servo Amplifier Instruction Manual (Motion Mode)
MELSERVO-J4 MR-J4 Servo Amplifier Instruction Manual (Troubleshooting)
MELSERVO Servo Motor Instruction Manual (Vol. 3) (Note 1)
MELSERVO Linear Servo Motor Instruction Manual (Note 2)
MELSERVO Direct Drive Motor Instruction Manual (Note 3)
MELSERVO Linear Encoder Instruction Manual (Note 2, 4)
MELSERVO EMC Installation Guidelines
Note 1. It is necessary for using a rotary servo motor.
2. It is necessary for using a linear servo motor.
3. It is necessary for using a direct drive motor.
4. It is necessary for using a fully closed loop system.
DISPOSAL OF WASTE
Manual name
A - 7
Manual No.
SH(NA)030218ENG
SH(NA)030109ENG
SH(NA)030113ENG
SH(NA)030110ENG
SH(NA)030112ENG
SH(NA)030111ENG
IB(NA)67310ENG