Unpacking And Verifying The Shipped Contents - Cisco ASR 907 Hardware Installation Manual

Preparing for Installation
Warning
Only trained and qualified personnel should be allowed to install or replace this equipment. Statement 49

Unpacking and Verifying the Shipped Contents

When you receive your chassis, perform the following steps and use the Shipping Contents Checklist.
Procedure
Step 1
Inspect the box for any shipping damage. If there is obvious physical damage, contact your Cisco service
representative.
Step 2
Unpack the Cisco ASR 907 Router.
Step 3 Perform a visual inspection of the chassis.
Step 4
Use the table below to check the contents of the Cisco ASR 907 Router shipping container. Do not discard
the shipping container. You will need the container if you move or ship the Cisco ASR 907 Router in the
future.
Table 7: Cisco ASR 907 Router Shipping Container Contents
Component
Chassis
Accessories kit
ESD, wrist strap (disposable)
Documentation
Description
Cisco ASR 907 Router chassis
Fan tray
Power supplies
RSP
Interface modules
Chassis rack-mount brackets (19-inch EIA)
Three sets of screws:
• Front and rear rack-mount bracket screws (2 sets)
• Cable-management bracket screws
Six cable-management brackets (one per bracket)
One earth lug with two 10-32 screws.
1 RJ45 to RJ45 crossover cable
1 RJ45 to DB-9 (female) adapter
One disposable wrist strap (optional)
Regulatory Compliance and Safety Information for the Cisco ASR 907 Router
Unpacking and Verifying the Shipped Contents
Cisco ASR 907 Router Hardware Installation Guide
53